Now you don't need to lie on dirt or sealed roads anymore, struggling to extract the spare wheel from underneath your vehicle. Kaymar's range of Spare Wheel Carriers puts the spare where it should be. On the back of your vehicle!

The standard bar Spare Wheel Carrier, mounts directly to the chassis over the existing bumper. This robust Spare Wheel Carrier pivots on sealed taper bearings, for a smooth swing and minimum maintenance. It's simple to use too. The automatic lock-open mechanism prevents the carrier swinging closed when the vehicle is on uneven ground. When closed, it locks securely in place, with Kaymar's efficient, easy-to-use, over-centre, manual locking system.
 

A definite asset to your 4WD. Our range of Replacement Rear Step Towbars are vehicle specific and there's one to perfectly suit most popular 4WD makes and models.

Each model is a rated and tested towbar in accordance with the National Australia Testing Authorities testing procedures.

The bar for the Toyota 60-62 series is available with a right-hand-side and left-hand-side pivot point, permitting fitment of a Spare Wheel Carrier and Jerry Can Holder. They're also compatible with ARB's jack mount, for safe, secure raising of the vehicles rear.

Note* Warranty is void if a non Kaymar hitch is used in the Kaymar towbar

These rear bars designs are vehicle-specific, with a towing capacity of 2500KG and a ball download of 250KG.

They're made from steel, then zinc-plated and powder coated. A process that gives them durability, longevity and strength, so they're tough and functional. These rear bars are bolted on to the back of your 4WD and mounted to your chassis. It also gives you, your vehicle and its occupants added protection from rear impacts.
 

The Replacement Rear Step Towbar is bolted to your chassis and the Spare Wheel Carrier is then mounted to this. Then you're able to fit extra accessories to the carrier. For all the options, check out the accessories to the spare wheel carrier page

Note* Warranty is void if a non Kaymar hitch is used in the Kaymar towbar

This robust Spare Wheel Carrier pivots on sealed taper bearings, for smooth use and minimum maintenance. And it's so simple to use. The manual lock-open system prevents the carrier swinging closed when the vehicle is on uneven ground. There is a pin on a wire that you manually place in a holder to keep the carrier open and then manually remove from holder to close.
 

This Swing Away Jerry Can Holder is simple to use with an automatic lock-open mechanism to prevent the carrier swinging , no matter what angle your vehicle is on. When closed, it locks securely in place with our efficient, easy-to-use, over-centre, manual locking system. Available in the left-hand side only, it's made from steel, which is then powder coated It also comes with a plastic covered metal cable, crimped on one side, with provision for a padlock, sold separately, on the other side. This keeps your jerry can secure even in the roughest going. Pictured on the Toyota Land Cruiser 80 Series.